ELINBOND  UV 400

UV Curable Adhesive And Sealant

Discuss your application  Request a Technical Data Sheet  Request an MSDS

Product Description

ELINBOND UV 400 is a one component, UV curable, thixotropic paste adhesive and sealant. It bonds well to glass and plastic substrates like ABS, PP, PET, PVC.

ELINBOND UV 400 cures rapidly to form toughness, transparent bonds when exposed to ultraviolet light of sufficient irradiance. It has a dual cure mechanism so that areas shadowed from the UV light can be cured with heat. It features good chemical and solvent resistance and good electrical insulation.

Applications

ELINBOND UV 400 is a one component, UV curable, thixotropic paste adhesive and sealant. It bonds well to glass and plastic substrates like ABS, PP, PET, PVC.

ELINBOND UV 400 cures rapidly to form toughness, transparent bonds when exposed to ultraviolet light of sufficient irradiance. It has a dual cure mechanism so that areas shadowed from the UV light can be cured with heat. It features good chemical and solvent resistance and good electrical insulation.

Instructions For Use

Thoroughly read the information concerning health and safety contained in this bulletin before using. Observe all precautionary statements that appear on the product label and/or contained in individual Material Safety Data Sheets (MSDS) 

To ensure the long term performance of the bonded assembly, complete cleaning of the substrates should be performed to remove contamination such as oxide layers, dust, moisture, salt, and oils which can cause poor adhesion or corrosion in a bonded part. For information on proper substrate preparation, refer to the reprint “Good Adhesive Bonding Starts with Surface Preparation” available from E-LINKING Co., Ltd . 

This product is light sensitive; exposure to daylight, UV light and artificial lighting should be kept to a minimum during storage and handling. The product should be dispensed from applicators.with black feedlines.

Cooling  should  be  provided  for temperature  sensitive  substrates  such  as thermoplastics. Plastic grades should be checked for risk of stress cracking when exposed to liquid adhesive. Excess uncured adhesive can be wiped away with organic solvent (e.g. Acetone). Bonds should be allowed to cool before subjecting to any service loads. Apply the adhesive to all surfaces to be bonded and join together. In most applications only contact pressure is required.

Packaging

Cans	Double Barrel Cartridge	FlexiPak™	Gun Applicator	Premixed & Frozen Syringe	Syringes

Request Information

Discuss your application  Request a Technical Data Sheet  Request an MSDS